How to make cornhole legs
Step 1
Cut the legs (D), stretchers (E) and braces (F) to length (Project Diagram, Cutting List). Cut the 11-degree angle on one end of each leg. Mark the center point on the width of the board 1-1/4 inches from the end and draw the 1-1/4-inch radius on the other end of each leg (Project Diagram, Drawing 2). Round off the ends of the legs with a jigsaw.
Step 2
Drill two countersunk pilot holes through each leg (Project Diagram, Drawing 2). Screw the pairs of legs to the stretchers (E).
Step 3
Drill countersunk screw holes in the braces (F). Fasten each to a legs/stretcher assembly with the top edge of the braces and top face of the stretcher flush (Project Di
agram, Drawing 2).
Tags: